Paradyne 7112 User Manual download pdf (Page 117)

MIB Descriptions

C-15

7112-A2-GB20-20

March 1998

Table C-7. DS1 Near End Group Configuration Table Objects (3 of 4)

Object, OID, Access Setting/ContentsDescription

dsx1LoopbackConfig

(dsx1ConfigEntry 9)

1.3.6.1.2.1.1.10.18.6.1.9

read-write

This object specifies the

loopback state of the

network interface.

Applies to the T1 network

interface only.

Supports the following

values:

 dsx1NoLoop(1) – The T1

interface is not in a

loopback state.

 dsx1PayloadLoop(2) –

Specifies that a Payload

Loopback (PLB) is active

for the network interface.

 dsx1LineLoop(3) –

Specifies that a Line

Loopback (LLB) is active

for the network interface.

 dsx1OtherLoop(4) –

Specifies that an

unspecified type of

loopback is active for the

network interface.

dsx1LineStatus

(dsx1ConfigEntry 10)

1.3.6.1.2.1.1.10.18.6.1.10

read-only

This object specifies the

line (alarm) status of the

network interface.

More than one value may be

active at a time.

Supports the following

values:

 dsx1NoAlarm(1) – No

alarm present.

 dsx1RcvFarEndLOF(2) –

A yellow alarm signal is

being received.

 dsx1RcvAIS(8) – An

Alarm Indication Signal

(AIS) is being received.

 dsx1LossOfFrame(32) –

An Out Of Frame condition

has persisted for more

than

2.5 seconds (i.e., Red

Alarm).

 dsx1LossOfSignal(64) –

A Loss of Signal condition

has persisted for more

than

2.5 seconds (i.e., Red

Alarm).

 dsx1LoopbackState(128)

– The near end of the

network interface is in a

loopback state.

 dsx1Other Failure(4096)

– An Excessive Error Rate

(EER) has been detected

on the network interface.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 155 156

Comments to this Manuals

No comments

Paradyne 7112 User Manual Page 117

Comments to this Manuals

Related products and manuals for Hardware Paradyne 7112