Paradyne 7112 User Manual Page 49
- Page / 156
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Monitoring the DSU/CSU
6-7
7112-A2-GB20-20
March 1998
Health and Status Messages
The following messages appear in the first column of the System and Test Status
screen. The highest priority Health and Status message also appears on all ATI
screens on the bottom right.
Table 6-2. Health and Status Messages (1 of 2)
Message
What Message Indicates What To Do
Loss Of Signal No signal is being received.
Local DSU/CSU network
problem. An LOS condition
(175 consecutive zeros) has
been detected on the network
interface.
1. Verify that the network cable is
securely attached at both ends.
2. Contact network provider.
Out of Frame DSU/CSU is detecting an out
of frame condition. This
occurs when two out of four
frame synchronization bits are
in error.
1. Wait for the condition to clear.
2. Verify that the line framing format
configuration option matches the
setting of the network.
3. Contact network provider.
Alarm Indication
Signal
An Alarm Indication Signal
(unframed all ones signal) is
being received from the
network interface.
1. Check the status of the far-end
device(s).
2. Contact network provider.
Excessive Error
Rate
An Excessive Error Rate
condition has been detected
on the network interface. The
condition is cleared when the
error rate falls below the
threshold value.
1. Contact network provider.
Yellow Alarm A Yellow Alarm signal is being
received from the network
interface.
1. Check the status of the far-end
device.
2. Contact network provider.
Primary Clock
Failed
The primary clock has failed.
Timing for the DSU/CSU is
provided by the internal clock.
1. Check the clock source
connector (DTE or Net).
2. If the primary clock was derived
from the network, contact the
network provider.
FDL Link Down The FDL communication
between the local and remote
DSU/CSU is not working.
1. Verify that the remote unit has
FDL enabled.
2. Contact network provider if
problem persists.
Device Fail
yyyyyyyy
An internal error has been
detected by the operating
software.
yyyyyyyy
indicates
the 8-digit hexadecimal failure
code.
1. Select the Clear function from the
Status screen.
2. Provide the 8-digit failure code
shown (
yyyyyyyy
) to your service
representative.
- MODEL 7112 T1 DSU/CSU 1
- Printed on recycled paper 2
- Contents 3
- 3 Configuring the DSU/CSU 4
- 4 Security 4
- 5 IP Addressing 4
- 6 Monitoring the DSU/CSU 5
- 7 Testing 5
- A Configuration Option Tables 6
- B Worksheets 6
- C MIB Descriptions 7
- E Cables and Pin Assignments 8
- F Technical Specifications 8
- About This Guide 9
- Product-Related Documents 10
- About the T1 DSU/CSU 11
- DSU/CSU DSU/CSU 12
- Router Router 12
- 7112-A2-GB20-20 13
- March 1998 13
- CAUTION: 14
- Using the ASCII Terminal 15
- Interface (ATI) 15
- If security is enabled 16
- Security 16
- If the ATI is already in use 16
- Screen Work Areas 17
- Screen Format Types 17
- Keyboard Keys 18
- " Procedure 19
- Screen Function Keys 20
- Procedure 20
- Ending an ATI Session 21
- Configuring the DSU/CSU 23
- Saving Configuration Options 25
- Main Menu 26
- Configuration 26
- Load Configuration From 26
- Cross Connect 26
- Creating a Login 30
- Deleting a Login 31
- ATI Access 32
- Effective Access Level 33
- Controlling SNMP Access 34
- SNMP NMS Security Options 35
- IP Addressing 37
- IP Addressing Examples 38
- Monitoring the DSU/CSU 43
- Display LEDs 44
- Troubleshooting 45
- Troubleshooting 46
- Port LEDs 47
- System and Test Status 48
- Health and Status Messages 49
- (xxxxxxxx 50
- Test Status Messages 51
- Cross Connect Status 52
- Summary Information 54
- Interval Table 54
- Worst Interval 55
- 24-Hour Totals 56
- DSU/CSU LEDs 59
- Configuring SNMP Traps 59
- Messages and Troubleshooting 59
- Network Tests 61
- Line Loopback 62
- Payload Loopback 62
- Repeater Loopback 63
- Remote Send Line Loopback 64
- Test Patterns for the Network 64
- Data Terminal Loopback 66
- Data Channel Loopback 67
- Send V.54 Up/Down Sequences 68
- Send FT1 Up/Down Sequences 69
- Test Patterns for the DTE 69
- Lamp Test 70
- Ending an Active Test 70
- Configuration Option Tables 77
- Cross Connect Assignments 83
- Data Port Options Menu 84
- Ethernet Port Options Menu 87
- Terminal Port Options 88
- ATI Access 89
- Telnet Session Options 90
- Creating a Login 91
- SNMP Menu 92
- SNMP Traps Options 95
- Network Interface 98
- Data Port 99
- Default in [Bold] 100
- Worksheets 101
- MIB Descriptions 103
- System Group 104
- Interfaces Group 105
- Network 109
- Data Port 109
- Ethernet Port 109
- Terminal Port 109
- (ifXEntry 15) 110
- (ifXEntry 17) 110
- (ifStackEntry1) 110
- (ifStackEntry2) 110
- Interface Test Table 111
- Generic Receive Address Table 111
- IP Group 111
- Do not specify the following 113
- (transmission 7) 114
- (transmission 33) 114
- (dsx1ConfigEntry 3) 115
- (dsx1ConfigEntry 4) 115
- (dsx1ConfigEntry 5) 115
- 1 to 7FFFFFFF 119
- Ethernet-Like MIB – RFC 1643 122
- RS-232-Like MIB – RFC 1659 122
- (rs232PortEntry 2) 123
- (rs232PortEntry 3) 123
- (rs232PortEntry 4) 123
- (rs232PortEntry 6) 123
- (rs232AsyncPortEntry 2) 124
- (rs232AsyncPortEntry 3) 124
- (rs232AsyncPortEntry 4) 124
- (rs232AsyncPortEntry 5) 124
- (rs232SyncPortEntry 2) 125
- (rs232SyncPortEntry 8) 125
- (rs232SyncPortEntry 9) 125
- (rs232SyncPortEntry 10) 125
- (rs232SyncPortEntry 12) 126
- (rs232SyncPortEntry 14) 126
- (rs232InSigEntry 2) 126
- (rs232InSigEntry 3) 126
- (rs232InSigEntry 4) 126
- (rs232OutSigEntry 2) 127
- (rs232OutSigEntry 3) 127
- (rs232OutSigEntry 4) 127
- (ifExtnsTestEntry 128
- Continued on next page 128
- Enterprise MIB Object 131
- Standards Compliance for 133
- SNMP Traps 133
- SNMP message not properly 134
- Three unsuccessful attempts 134
- IP address security is 134
- Traps: linkUp and linkDown 134
- Traps: enterpriseSpecific 136
- 7112-A2-GB20-10March 1998 138
- Cables and Pin Assignments 139
- 10BaseT Connector 141
- Serial Crossover Cable 142
- DTE V.35 Connector 143
- Technical Specifications 145
- Item Specifications 146
- Glossary 147
Related products and manuals for Hardware Paradyne 7112
Hardware Paradyne 3511 DSU User Manual
(4 pages)
(4 pages)
Hardware Paradyne 3800PLUS User Manual
(217 pages)
(217 pages)
Hardware Paradyne HOTWIREt 7984 User Manual
(122 pages)
(122 pages)
Hardware Paradyne 3162 User Manual
(23 pages)
(23 pages)
Hardware Paradyne CSU User Manual
(470 pages)
(470 pages)
Hardware Paradyne 3160 User Manual
(296 pages)
(296 pages)
Hardware Paradyne ACCULINK 317x E1 User Manual
(167 pages)
(167 pages)
Hardware Paradyne 6212 User Manual
(102 pages)
(102 pages)
Hardware Paradyne AT&T 3921 User Manual
(2 pages)
(2 pages)
Hardware Paradyne Hotwire 7975 User Manual
(124 pages)
(124 pages)
Hardware Paradyne 6381 User Manual
(46 pages)
(46 pages)
Hardware Paradyne 3910 User Manual
(278 pages)
(278 pages)
Hardware Paradyne COMSPHERE 3615 User Manual
(135 pages)
(135 pages)
Hardware Paradyne 3800 User Manual
(125 pages)
(125 pages)
Hardware Paradyne 6211-I1 User Manual
(3 pages)
(3 pages)
© 2020, manymanuals.com. All rights reserved. | 0.201 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals