Paradyne 7112 User Manual Page 151
- Page / 156
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Glossary
GL-5
7112-A2-GB20-20
March 1998
An EIA standard for the 25-pin DCE/DTE interface. Same as EIA-232.
Request to Send. An EIA-lead standard for V.24 circuit CT 105; an input signal
(DTE-to-DCE).
Received Clock. An EIA-lead standard for V.24 circuit CT 115; an output signal
(DCE-to-DTE).
Received Data. An EIA-lead standard for V.24 circuit CT 104; an output signal
(DCE-to-DTE).
Synchronous Data Link Control. A standard data link protocol.
A test that checks most hardware components when power is applied to the device or a
reset is initiated.
Severely Errored Seconds. For T1 data, seconds with 320 or more CRC6 errors or errored
frame alignment signals.
Serial Line Internet Protocol. A link layer protocol being used over serial lines by IP.
Simple Network Management Protocol. A generic internet network management protocol
that allows the device to be managed by any industry-standard SNMP manager.
An IP addressing standard in which a portion of the host address can be used to create
multiple network addresses that are logically a subdivision of the network address.
The subnet portion of an IP address. In a subnetted network, the host portion of an IP
address is split into a subnet portion and a host portion using a subnet address mask. This
allows a site to use a single IP network address for multiple physical networks.
An integer used with the IP address of the host to determine which bits in the host address
are used in the subnet address.
Data transmission that is synchronized by timing signals. Characters are sent at a fixed
rate.
Transmission Control Protocol/Internet Protocol. Refer to IP.
Time Division Multiplexer. A device that enables the simultaneous transmission of multiple
independent data streams into a single high-speed data stream.
Virtual terminal protocol in the Internet suite of protocols. Allows the user of one host
computer to log into a remote host computer and interact as the user for that host.
The allocated DS0 channel slot when DS0 channels are combined to form an aggregate
bit stream.
Test Mode. An EIA-lead standard for V.24 circuit CT 142; an output signal (DCE-to-DTE).
A notification message to the SNMP manager when an unusual event occurs on a network
device, such as a reinitialization.
Transmit. To send signals from a device.
Transmit Clock. An EIA-lead standard for V.24 circuit CT 114; an output signal
(DCE-to-DTE).
Transmit Data. An EIA-lead standard for V.24 circuit CT 103; an input signal
(DTE-to-DCE).
A wideband digital interface operating at 1.544 Mbps.
Unavailable Seconds. A count of 1-second intervals when service is unavailable.
User Datagram Protocol. An Internet protocol.
RS-232
RTS
RXC
RXD
SDLC
self-test
SES
SLIP
SNMP
subnet
subnet address
subnet mask
synchronous
TCP/IP
TDM
Telnet
time slot
TM
trap (SNMP)
TX
TXC
TXD
T1
UAS
UDP
- MODEL 7112 T1 DSU/CSU 1
- Printed on recycled paper 2
- Contents 3
- 3 Configuring the DSU/CSU 4
- 4 Security 4
- 5 IP Addressing 4
- 6 Monitoring the DSU/CSU 5
- 7 Testing 5
- A Configuration Option Tables 6
- B Worksheets 6
- C MIB Descriptions 7
- E Cables and Pin Assignments 8
- F Technical Specifications 8
- About This Guide 9
- Product-Related Documents 10
- About the T1 DSU/CSU 11
- DSU/CSU DSU/CSU 12
- Router Router 12
- 7112-A2-GB20-20 13
- March 1998 13
- CAUTION: 14
- Using the ASCII Terminal 15
- Interface (ATI) 15
- If security is enabled 16
- Security 16
- If the ATI is already in use 16
- Screen Work Areas 17
- Screen Format Types 17
- Keyboard Keys 18
- " Procedure 19
- Screen Function Keys 20
- Procedure 20
- Ending an ATI Session 21
- Configuring the DSU/CSU 23
- Saving Configuration Options 25
- Main Menu 26
- Configuration 26
- Load Configuration From 26
- Cross Connect 26
- Creating a Login 30
- Deleting a Login 31
- ATI Access 32
- Effective Access Level 33
- Controlling SNMP Access 34
- SNMP NMS Security Options 35
- IP Addressing 37
- IP Addressing Examples 38
- Monitoring the DSU/CSU 43
- Display LEDs 44
- Troubleshooting 45
- Troubleshooting 46
- Port LEDs 47
- System and Test Status 48
- Health and Status Messages 49
- (xxxxxxxx 50
- Test Status Messages 51
- Cross Connect Status 52
- Summary Information 54
- Interval Table 54
- Worst Interval 55
- 24-Hour Totals 56
- DSU/CSU LEDs 59
- Configuring SNMP Traps 59
- Messages and Troubleshooting 59
- Network Tests 61
- Line Loopback 62
- Payload Loopback 62
- Repeater Loopback 63
- Remote Send Line Loopback 64
- Test Patterns for the Network 64
- Data Terminal Loopback 66
- Data Channel Loopback 67
- Send V.54 Up/Down Sequences 68
- Send FT1 Up/Down Sequences 69
- Test Patterns for the DTE 69
- Lamp Test 70
- Ending an Active Test 70
- Configuration Option Tables 77
- Cross Connect Assignments 83
- Data Port Options Menu 84
- Ethernet Port Options Menu 87
- Terminal Port Options 88
- ATI Access 89
- Telnet Session Options 90
- Creating a Login 91
- SNMP Menu 92
- SNMP Traps Options 95
- Network Interface 98
- Data Port 99
- Default in [Bold] 100
- Worksheets 101
- MIB Descriptions 103
- System Group 104
- Interfaces Group 105
- Network 109
- Data Port 109
- Ethernet Port 109
- Terminal Port 109
- (ifXEntry 15) 110
- (ifXEntry 17) 110
- (ifStackEntry1) 110
- (ifStackEntry2) 110
- Interface Test Table 111
- Generic Receive Address Table 111
- IP Group 111
- Do not specify the following 113
- (transmission 7) 114
- (transmission 33) 114
- (dsx1ConfigEntry 3) 115
- (dsx1ConfigEntry 4) 115
- (dsx1ConfigEntry 5) 115
- 1 to 7FFFFFFF 119
- Ethernet-Like MIB – RFC 1643 122
- RS-232-Like MIB – RFC 1659 122
- (rs232PortEntry 2) 123
- (rs232PortEntry 3) 123
- (rs232PortEntry 4) 123
- (rs232PortEntry 6) 123
- (rs232AsyncPortEntry 2) 124
- (rs232AsyncPortEntry 3) 124
- (rs232AsyncPortEntry 4) 124
- (rs232AsyncPortEntry 5) 124
- (rs232SyncPortEntry 2) 125
- (rs232SyncPortEntry 8) 125
- (rs232SyncPortEntry 9) 125
- (rs232SyncPortEntry 10) 125
- (rs232SyncPortEntry 12) 126
- (rs232SyncPortEntry 14) 126
- (rs232InSigEntry 2) 126
- (rs232InSigEntry 3) 126
- (rs232InSigEntry 4) 126
- (rs232OutSigEntry 2) 127
- (rs232OutSigEntry 3) 127
- (rs232OutSigEntry 4) 127
- (ifExtnsTestEntry 128
- Continued on next page 128
- Enterprise MIB Object 131
- Standards Compliance for 133
- SNMP Traps 133
- SNMP message not properly 134
- Three unsuccessful attempts 134
- IP address security is 134
- Traps: linkUp and linkDown 134
- Traps: enterpriseSpecific 136
- 7112-A2-GB20-10March 1998 138
- Cables and Pin Assignments 139
- 10BaseT Connector 141
- Serial Crossover Cable 142
- DTE V.35 Connector 143
- Technical Specifications 145
- Item Specifications 146
- Glossary 147
Related products and manuals for Hardware Paradyne 7112
Hardware Paradyne 3511 DSU User Manual
(4 pages)
(4 pages)
Hardware Paradyne 3800PLUS User Manual
(217 pages)
(217 pages)
Hardware Paradyne HOTWIREt 7984 User Manual
(122 pages)
(122 pages)
Hardware Paradyne 3162 User Manual
(23 pages)
(23 pages)
Hardware Paradyne CSU User Manual
(470 pages)
(470 pages)
Hardware Paradyne 3160 User Manual
(296 pages)
(296 pages)
Hardware Paradyne ACCULINK 317x E1 User Manual
(167 pages)
(167 pages)
Hardware Paradyne 6212 User Manual
(102 pages)
(102 pages)
Hardware Paradyne AT&T 3921 User Manual
(2 pages)
(2 pages)
Hardware Paradyne Hotwire 7975 User Manual
(124 pages)
(124 pages)
Hardware Paradyne 6381 User Manual
(46 pages)
(46 pages)
Hardware Paradyne 3910 User Manual
(278 pages)
(278 pages)
Hardware Paradyne COMSPHERE 3615 User Manual
(135 pages)
(135 pages)
Hardware Paradyne 3800 User Manual
(125 pages)
(125 pages)
Hardware Paradyne 6211-I1 User Manual
(3 pages)
(3 pages)
© 2020, manymanuals.com. All rights reserved. | 0.117 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals