Paradyne ACCULINK 316x User Manual Page 28
- Page / 211
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Installation
2-53160-A2-GB22-10 December 1996
Box Contents
The 3160/3164 DSU/CSU product arrives in a single
box and should contain the following:
•
One 3160/3164 DSU/CSU standalone unit
• One 14.5 foot VF cable
• One power transformer
• One
ACCULINK 3160/3164 DSU/CSU Refer
ence
Card
• One
ACCULINK 316x Data Service Unit/Channel
Service Unit Operator
’
s Guide
Please refer all servicing to qualified personnel. The
Download front panel branch is dedicated to DSU/CSU
service and maintenance and is not intended for use by the
customer.
The 3100 Series Front Panel Emulation software is
available separately and is described in the
Front Panel
Emulation Software Installation
section later in this
chapter.
Important Safety Instructions
Read and follow all warning notices and instructions
marked on the 316x DSU/CSU or included in this guide.
NOTE
The Download command is for
use by service personnel only.
Loss of primary data could result
from improper use.
HANDLING PRECAUTIONS
FOR
STA
TIC-SENSITIVE DEVICES
This product is designed to protect
sensitive components from damage
due to electrostatic discharge (ESD)
during normal operation. When
performing installation procedures,
however, take proper static control
precautions to prevent damage to
equipment. If you are not sure of the
proper static control precautions,
contact your near
est sales or service
representative.
For a complete listing of the safety instructions, see the
Important Safety Instructions
section earlier in this guide.
Quick Start Procedure
The following procedure is for experienced DSU/CSU
users who are familiar with the 3160/3164 DSU/CSU
installation process and have no special requirements for
their application.
1. Attach the power cord to the rear of the DSU/CSU
and the other end to a grounded 115 Vac power
outlet.
2. Attach the 3160/3164 DSU/CSU network
connection to the T1 network using the
appropriate cable. Attach the 3160/3164
DSU/CSU to the CPE via the DTE (DSX-1)
and/or ports connectors. Adapter cables are
available which allow RS449 or V
.35 devices to
be supported from the EIA 530A connector on the
rear panel. Refer to Appendix H, Equipment List.
See the
3160/3164 DSU/CSU Cabling
section later
in this chapter for more cabling information.
3. Power on the DSU/CSU to perform the power-up
self-test. See the
Power-Up Self-Test
section later
in this chapter for more information.
4. To perform front panel emulation, connect the
cable from the PC to the COM port on the rear
panel of the DSU/CSU. To perform device
management from an async terminal, connect the
terminal to the COM port (or for dial-in access,
the modem port) on the rear panel of the
DSU/CSU. See the 3160/3164 DSU/CSU
Cabling
section later in this chapter for more cabling
information.
- ACCULINK 1
- 316x DATA SERVICE UNIT/ 1
- CHANNEL SERVICE UNIT 1
- (INCLUDES TERMINAL USER 1
- INTERFACE) 1
- United States 5
- Government Requirements 7
- Table of Contents 8
- 3. Operation 9
- 4. Maintenance 9
- Appendices 9
- List of Figures 10
- List of Tables 12
- Objectives and Reader 14
- Assumptions 14
- Related Documents 14
- Reference Documents 14
- Introduction 15
- Features 16
- Physical Description 18
- 3160/3164 DSU/CSU Front Panel 18
- 3160/3164 DSU/CSU Rear Panel 18
- Table 1-1 21
- Connector Name 21
- Model 3161 DSU/CSU Rear Panel 22
- Installation 24
- SERVICES 25
- FRACTIONAL T1 26
- Box Contents 28
- Important Safety Instructions 28
- Quick Start Procedure 28
- Optional Power Selection 29
- Power-Up Self-Test 32
- Selecting a Model 3161 33
- DSU/CSU Identity 33
- Establishing Access Security 35
- Setting/Changing a Password 35
- 3160/3164 DSU/CSU Cabling 37
- Factory Default Configuration 39
- Installing Front Panel 39
- Emulation Software 39
- Enabling/Disabling the Front 40
- 3160/3164 DSU/CSU User 41
- Interface Access Security 41
- Operating the Front Panel 45
- 496-14392-0 46
- Other Displays 47
- Table 3-1 49
- System LEDs 49
- Color Meaning 49
- Table 3-2 50
- NETWORK Interface LEDs 50
- Table 3-3 51
- DSX-1 Drop/Insert Port LEDs 51
- Table 3-4 52
- Data Port LEDs 52
- Front Panel Emulation on a PC 55
- Test Jacks 56
- Configuring the DSU/CSU 58
- Configuration Procedures 59
- Saving Edit Changes 62
- Selecting a Specific Port 63
- To Copy to One or All Ports 65
- Selecting the Port 66
- Setting the IP Address 68
- Access Type(s) 71
- Configuring DS0 Channels 76
- Allocating Data Ports 84
- 496-14341a-01 91
- Selecting the Shared 94
- Communication Port 94
- Checking the Status of the 95
- Table 3-9 96
- Health and Status Messages 96
- Self-Test Health 97
- Displaying Self-Test Results 98
- Performance Report 99
- Table 3-11 100
- (2 of 2) 100
- Performance Registers 100
- Operation 101
- ACCULINK 316x DSU/CSU 102
- Controlling the DSU/CSU 103
- Interface 104
- Starting Front Panel 111
- Emulation 111
- Using the Async Terminal 112
- COM Use:Term Modem Use:Term 112
- Char Length:8 Char Length:8 112
- Dial-In:Enab 112
- Customer ID: New Cust 113
- Model: ACCULINK XXXX 113
- Enter Password: _________ 113
- Menu Selection Screens 114
- Edit and Display Screens 114
- Terminating a Session 116
- Maintenance 117
- SNMP Traps 118
- Test Commands 119
- Remote Loopback Tests 120
- Sending a V.54/ANSI FT1 121
- Activation/Deactivation 121
- Starting a Line Loopback 122
- Starting a Payload Loopback 123
- Starting a DTE Loopback 123
- Starting a Repeater Loopback 124
- DTE-initiated Loopbacks 127
- Aborting Loopbacks 127
- Sending Test Patterns 128
- Monitoring Test Patterns 129
- Aborting Test Patterns 130
- Starting a Lamp Test 130
- Aborting a Lamp Test 131
- Downloading Software 133
- Resetting the DSU/CSU 133
- Front Panel Menu A 135
- Front Panel Menu 137
- Technical Specifications 138
- Table B-1 139
- Specifications Criteria 139
- Table B-2 140
- (1 of 2) 140
- Configuration Options 142
- Context-Sensitive Menu 143
- DTE Interface Configuration 143
- Table C-1 144
- Port Configuration Options 145
- Table C-2 146
- (2 of 3) 146
- (3 of 3) 147
- Network Interface 148
- Table C-3 149
- Channel Configuration 150
- Table C-5 151
- General Configuration Options 153
- User Interface Configuration 154
- Table C-7 155
- (2 of 4) 155
- (3 of 4) 156
- (4 of 4) 157
- Alarm Configuration Options 158
- Table C-8 159
- SNMP Configuration Options 161
- Table C-9 162
- Table C-10 163
- Pin Assignments 165
- Receiver Ring 1 166
- Receiver Tip 2 166
- Transmitter Ring 4 166
- Transmitter Tip 5 166
- Receiver Ring 1 11 167
- Receiver Tip 2 3 167
- Transmitter Ring 4 9 167
- Transmitter Tip 5 1 167
- DSX-1 Port DTE Interface 168
- Integral Modem Service Port 169
- VF Ring 2 169
- VF Tip 3 169
- AUX Port Interface 170
- COM Port Interface 171
- Table D-6 172
- COM Port Connector (J6) 172
- Direction Pin Number 172
- EIA-530A DB25 Port Interface 173
- Connector 173
- RS449 Port Interface 174
- V.35 Port Interface Connector 176
- Power Cable 178
- Power Input Connector 178
- External Clock Connector 179
- Slide Latch Adapter 180
- SNMP MIB Objects 181
- Management Information Base 182
- (MIB) II (RFC 1213) 182
- (ifEntry 7) 185
- DS1/E1 MIB (RFC 1406) 187
- RS-232-like MIB (RFC 1317) 190
- Generic-Interface MIB 193
- Extensions (RFC 1229) 193
- Troubleshooting Table 195
- Table F-1 196
- Troubleshooting 196
- Configuration Worksheets 197
- Port Chan 202
- Options Value 202
- Equipment List 205
- Glossary 206
Related products and manuals for Networking Paradyne ACCULINK 316x
Networking Paradyne 8540 User Manual
(161 pages)
(161 pages)
Networking Paradyne U8777 User Manual
(182 pages)
(182 pages)
Networking Paradyne 3166 CSU User Manual
(206 pages)
(206 pages)
Networking Paradyne 8784 User Manual
(110 pages)
(110 pages)
Networking Paradyne 6218 User Manual
(78 pages)
(78 pages)
Networking Paradyne ENE2020-P User Manual
(16 pages)
(16 pages)
Networking Paradyne 7610 User Manual
(127 pages)
(127 pages)
© 2020, manymanuals.com. All rights reserved. | 1.719 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals