Paradyne ACCULINK 316x User Manual download pdf (Page 87)

Operation

3-453160-A2-GB22-10 December 1996

4. The Start At screen displays the configuration

option used to select the starting DS0 channel. If

the destination selected is the Network T1

interface, then the Network channels appear on the

screen. If the destination selected is the DSX-1

DS-1 Drop/Insert T1 interface, then these channels

appear on the screen. The following screen shows

an example of the Network T1 interface. Use the

or key to scroll the desired channel onto

the screen. Use the Function keys to select the

starting channel. Only those DS0 channel numbers

that provide enough bandwidth (based on the

configured data rate) to be used as a starting

channel number are displayed.

Start

t:Clear

Next Clear N1

Individual Channel Assignment Method

Example

The

Assign By configuration option screen appears

after you select a port. T

o assign by the individual channel

method,

Press the

key once to bring the Chan selection

onto the screen.

Assign

y:Block

Next Bloc

k A

CAMI

2. Press F3 (Chan).

Assign

y:Chan

Block ACAMI Chan

3. Press F1 (Next) to display the next configuration

option (channel allocation).

Assign

y:Chan

Next Bloc

k A

CAMI

4. Line

1 displays the 24 channels for the Network

T1 interface or the DSX-1 Drop/Insert T1

interface, depending on which destination was

chosen. This example assumes that the Network

T1 interface is the destination. Line 2 displays

what is allocated to the DS0 channel shown in

Line 1. Pressing the or

key scrolls the

channels onto the screen in groups of three.

Possible values for Line 2 are listed in Table 3-7.

Select the channel by pressing the Function key

under the desired number. Portn appears. The port

is assigned to that channel. T

o unallocate a port,

press the Function key under that port number.

Pressing the Function key under channels assigned

to other ports has no effect.

N1 N2

Next Prt1 Prt2

Allocating DS0 Channels from the DSX-1

Drop/Insert T1 Interface to the Network T1

Interface

You can allocate DS0 channels from the DSX-1

Drop/Insert T1 interface to the Network interface and

specify which DS0 channels carry Robbed Bit

Signaling (RBS) information for voice channels.

To allocate DS0 channels from the DSX-1 Drop/Insert

T1 interface to the Network interface,

1. Press F3 to select Cnfig from the top-level menu

screen.

F1 F2

U E

Stat Test Cnfig

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 210 211

Comments to this Manuals

No comments

Paradyne ACCULINK 316x User Manual Page 87

Comments to this Manuals

Related products and manuals for Networking Paradyne ACCULINK 316x