Paradyne ACCULINK 316x User Manual download pdf (Page 86)

ACCULINK 316x DSU/CSU

3-44 December 1996 3160-A2-GB22-10

3. Use the or key to scroll the desired port

rate onto the screen. Rates scroll in groups of

three. A

vailable selections depend on the current

base rate selected for the port. Press the

corresponding Function key to select the port rate.

Then, select Next to display the Start At

configuration option on the screen.

Port Rate:384

Next 64 128

NOTE

For the 3164 DSU/CSU, there is a

hardware limitation that limits the

combined bandwidth used by

Port1 and Port3 to a total of

2048 kbps, and the combined

bandwidth used by Port2 and

Port4 to 2048 kbps. Thus, the rate

choices shall be limited

appropriately due to this

constraint. This limitation should

only occur in configurations

mapping a port to a port or when

mapping ports to the DSX-1 and

to the network.

4. The Start At screen displays the configuration

option used to select the starting DS0 channel. If

the destination selected is the Network T1

interface, then the Network channels appear on the

screen. If the destination selected is the DSX-1

DSX-1 Drop/Insert T1 interface, then the these

channels appear on the screen. The following

screen shows an example of the Network T1

interface. Use the

or key to scroll the

desired channel onto the screen. Use the Function

keys to select the starting channel. Only those DS0

channel numbers that provide enough bandwidth

(based on the configured data rate) to be used as a

starting channel number are displayed. Channel

allocation for this port only can be cleared by

selecting Clear

Start

t:Clear

Next Clear N1

ACAMI Channel Assignment Method Example

The

Assign By configuration option screen appears

after you select a port. T

o assign by the ACAMI method,

1. Press F3 (ACAMI).

Assign

y:Block

Next Bloc

k A

CAMI

2. Press F1 (Next) to display the next configuration

option (Port Rate).