Paradyne 9126-II User Manual download pdf (Page 386)

C. Router CLI Commands, Codes, and Designations

C-4

September 2002 9128-A2-GB20-80

Configuration Commands

Configuration control commands put the router in configuration mode and

allows you to save configuration changes. To show a configuration, see

Table C-13, Show Commands.

Table C-3. Configuration Commands

configure {terminal

factory

}

Minimum Access Level:

Administrator

Command Mode:

config

Causes the router to enter configuration mode. The router stays in configuration mode

until the

exit

command is entered or the session times out.

Example:

configure terminal

NOTES:

When in configuration mode:

– SNMP

set

commands or changes saved from the menu-driven user interface for

router configuration are prevented; an in use message is generated.

– Router sub-interfaces and/or DLCIs cannot be added or deleted via the

menu-driven user interface’s CreatePVC function key.

– The number of configuration commands that can be entered without performing a

save

is limited; a warning message is generated.

– The only

show

command available is

show configuration

terminal

– Enter configuration mode and a copy of the currently running configuration is

loaded into the edit buffer. Any changes made in the buffer overwrite the copied current

configuration when the

save

command is entered, the configuration is saved to the

currently running configuration (terminal), and an automatic reset is performed.

factory

– Enter configuration mode and a copy of the factory default settings is loaded

into the edit buffer. Any changes made in the buffer overwrite the copied default settings

when the

save

command is entered, the configuration is saved to the currently running

configuration (terminal), and an automatic reset is performed. This is the default.

save

Minimum Access Level:

Administrator

Command Mode:

All config modes

Causes configuration changes to be saved to the currently active configuration, and the

router to be reset.

If the

save

command is entered and changes made require a reboot of the device, a

prompt states that a reset is required for the changes to take effect.

– If

yes

is entered, changes are stored and the device resets automatically.

A message displays when the save is complete.

– If

is entered, you stay in configuration mode.

1 2 ... 381 382 383 384 385 386 387 388 389 390 391 ... 469 470

Comments to this Manuals

No comments

Paradyne 9126-II User Manual Page 386

Comments to this Manuals

Related products and manuals for Bridges & repeaters Paradyne 9126-II