Paradyne 9126-II User Manual download pdf (Page 341)

11. Setting Up Network Health for FrameSaver Devices

9128-A2-GB20-80 September 2002

11-7

About Trend Reports

By specifying specific variables like bandwidth, trend analysis can be performed

and shown on Trend Reports. Up to ten variables for a DLCI, or ten DLCIs on one

variable can be generated on a single trend report. Information can be presented

in a line graph, pie chart, bar chart, or table format. Any amount of time can be

specified for the reporting period.

These reports can help identify the reasons a DLCI has acquired a poor Health

Index rating. See the Exceptions Report for information about Health Index ratings.

Printed Reports

All of the charts and tables seen online can also be provided on printed reports.

Reports Applicable to SLV Devices

The following frame relay reports support FrameSaver SLV units:

Exception Reports

– Provide summary and detail information that identifies

DLCIs with the highest incidence of errors, high bandwidth utilization, and

trends.

These reports identify those DLCIs that have exceeded a specified number of

accumulated

exception points

. It is a good idea to run this report daily so that

DLCIs having the most problems can be attended to first. DLCIs contained on

this report need immediate attention.

If a DLCI suddenly shows up on these reports, check whether any new

equipment has been added to the network and whether it is properly

configured. If its configuration is correct, the equipment could be faulty.

Summary Reports

– Provide summary information for the network, volume

and error leaders, and DLCI traffic.

—

Network Summary Report

– Provides an overall view of the network.

Use this report for planning and to predict when a DLCI might run into

problems.

—

Leaders Summary Report

– Identifies DLCIs having the highest volume

and errors. High traffic volume may be increasing latency, and the high

Health Index rating indicates problems. It is a good idea to run these

reports daily so a norm can be established. The same DLCIs should

appear.

Use this chart and table to alert you to possible problems. Problems to

look for include: a normally high-volume DLCI is dropped from the list, a

new DLCI appears on the list (check Element Summaries), a DLCI has a

high Health Index rating, but low volume, significant differences between a

DLCI’s average and peak Health Index rating.

1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 469 470

Comments to this Manuals

No comments

Paradyne 9126-II User Manual Page 341

Comments to this Manuals

Related products and manuals for Bridges & repeaters Paradyne 9126-II