Paradyne 9126-II User Manual download pdf (Page 318)

100

101

10. Setting Up NetScout Manager Plus for FrameSaver Devices

10-4

September 2002 9128-A2-GB20-80

Adding FrameSaver SLV Units to the NetScout Manager Plus Network

Procedure

1. Bring up the NetScout Manager Plus main window.

2. Select the FrameRelay radio button from the agent type selection bar (on the

left side of the window).

A list of configured frame relay agents appear in the list box below the Name

and IP Address headings. If this is a new NetScout Manager Plus installation,

the list box below the selection bar is blank since no agents are configured yet.

3. Select the Admin radio button from the application selection bar (to the far

right of the screen). Applicable configuration and administration icons appear

in the box below the application bar.

4. Click on the Config Manager icon to open the Configuration Manager main

window.

5. Select the Add... button (down the center of the screen).

6. Minimally, enter the following:

— Agent name

— IP address

— Enter 1 for the frame relay logical interface to be monitored.

— Properties File: Select paradyne.

7. Select the OK button at the bottom of the screen to add the agent, discover its

DLCIs, and return to the Configuration Manager main window.

The frame relay agent just entered appears in the agent list box, with its DLCIs

in the DLCI list box at the bottom of the screen.

8. Select the Test button (fourth button down, center of the screen) to make sure

you can communicate with the agent.

Refer to

Adding Frame Relay Agents

in the

NetScout Manager/Plus & NetScout

Server Administrator Guide

for additional information.

1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 469 470

Comments to this Manuals

No comments

Paradyne 9126-II User Manual Page 318

Comments to this Manuals

Related products and manuals for Bridges & repeaters Paradyne 9126-II