Paradyne ACCULINK 3161 CSU User Manual

ACCULINK 3161 DSU/CSUQUICK REFERENCEDocument No. 3161-A2-GL11-40

8Table 4. DTE Drop/Insert Port Channel Configuration OptionsLine 1 Displays: Line 2 Displays: Meaning Comments/Description— UnassignedN1 N2 N3 ...

9Table 5. Data Port Channel Configuration Options (1 of 2)Option Factory 1 Factory 2 Comments/DescriptionNET NETAssigns this port to channels onAss

10Table 5. Data Port Channel Configuration Options (2 of 2)Option Factory 1 Factory 2 Comments/DescriptionClear ClearClears (unassigns) channels fo

11Table 6. General Configuration OptionsOption Factory 1 Factory 2 Comments/DescriptionGen Yellow:Enab EnabYellow alarm is generated by theGen Yell

12Table 7. User Configuration Options (1 of 3)Option Factory 1 Factory 2 Comments/DescriptionSelf-Test:Enab EnabAllows bypass of self-test onSelf-T

13Table 7. User Configuration Options (2 of 3)Option Comments/DescriptionFactory 2Factory 11.2 1.22.4 2.4Com Rate:4.8 4.8Com Rate:(Communication Po

14Table 7. User Configuration Options (3 of 3)Option Comments/DescriptionFactory 2Factory 15 5TnDiscTm: (Telnet DisconnectUp UpThe period of inacti

15Table 8. Alarm Configuration Options (2 of 2)Option Comments/DescriptionFactory 2Factory 1AlrmRelay:Enab EnabSpecifies whether to activate theAlr

16Table 9. General Management Configuration Options (2 of 2)Option Comments/DescriptionFactory 2Factory 1IP Adr:Edit EditThe IP address needed to a

17Table 10. Management Trap Configuration OptionsOption Factory 1 Factory 2 Comments/DescriptionNum Trap Mgrs:12–612–6The number of trap managerssu

Copyright  1998 Paradyne Corporation.All rights reserved.Printed in U.S.A.NoticeThis publication is protected by federal copyright law. No part of th

TM 1ACCULINK 3161 DSU/CSUQuick ReferenceDocument Number 3161-A2-GL11-40February 1998Quick Start ProcedureThe following procedure is for experienced DS

23. Attach the network cable to the Auxiliary Backplane using either a 50-pin cable orthe T1 Network Interface Adapter. Connect the other end of the

35. Insert the DSU/CSU circuit card into the appropriate slot in the carrier. Thepower-up self-test begins.495-147976. If you intend to use front pan

4Configuration OptionsConfiguration options are accessed from the Cnfig branch of the front panel menu.DSU ESFStat97-15577DevHSSTest Perf TSt at LED

5Table 1. DTE Interface Configuration OptionsOption Factory 1 Factory 2 Comments/DescriptionDTE Port:Enab EnabEnables the use of the DTEDTE Port:Di

6Table 2. Port Configuration Options (2 of 3)Option Comments/DescriptionFactory 2Factory 1Disab DisabPort LB:DTLB DTLBPort-initiated Loopbacks, all

7Table 2. Port Configuration Options (3 of 3)Option Comments/DescriptionFactory 2Factory 1Far end:Disab DisabSpecifies whether the device willmaint