1iMarc® 9550 DS3 ProbeInstallation InstructionsDocument Number 9550-A2-GN10-00September 2005ContentsSoftware and Firmware License Agreement ...
107. If the cable length is longer than 100 feet (30 meters), set the LBO on the T3 Network Interface Options configuration screen to Long. The defaul
11Connecting the Modem PortThe Probe supports asynchronous terminal interface sessions over its integral modem.ProcedureTo connect the Modem port:1. P
12Connecting the Console PortThe Console port can be used to connect a VT100-compatible terminal or a PC with terminal emulation software, providing d
13Using the Asynchronous Terminal InterfaceThe Probe should operate using the default (factory-set) configuration options, with exception to the chang
14Menu HierarchyThe Menu Hierarchy shows the organization of the Probe’s asynchronous terminal interface screens. St a t u s
15Configuration System Class of Service DefinitionsMonitored Protocol DefinitionsService Level VerificationGeneralNetwork PhysicalAT MVPI, VCI Recor
16Saving Configuration OptionsProcedureTo save a configuration option change:1. Press Ctrl-a to switch to the function keys area at the bottom of the
17EMI NoticesUnited States – EMI NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Pa
18Important Safety Instructions1. Read and follow all warning notices and instructions marked on the product or included in the manual.2. Slots and op
19Warranty, Sales, Service, and Training InformationContact your local sales representative, service representative, or distributor directly for any h
2Software and Firmware License Agreement The terms and conditions of this License Agreement (the “Agreement”) will apply to the software and/or firmwa
20*9550-A2-GN10-00**9550-A2-GN10-00*
3b. ANY AND ALL IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRI
4Unpacking and Inspecting the EquipmentHANDLING PRECAUTIONS FOR STATIC-SENSITIVE DEVICESThis product is designed to protect sensitive components from
5Installing in a RackTwo types of mounting screws are provided. Use: #10-32 mounting screws for rails with threaded screw holes #12-24 mounting scre
63. Insert and tighten the screws in the top screw positions, then tighten the bottom screws.Connecting to PowerThe Probe requires a 120 VAC, 60 Hz po
73. Plug the socket end of the power cord into the power receptacle on the back of the Probe.4. Plug the power cable into a 120 VAC, 60 Hz outlet.05-1
8Connecting the Subscriber PortThe Subscriber port connects to your DTE, such as a router.ProcedureTo connect the Subscriber port:1. If clearance at t
9Connecting to the DS3 NetworkThe Network port connects to the packet network .ProcedureTo connect the Network port:1. If clearance at the front of th
Comments to this Manuals