Paradyne Switch 6800 User Manual Page 65
- Page / 237
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
COMSPHERE 6800 Series Network Management System
2-42 January 1997 6800-A2-GB31-20
Set CCN event:
If configuration change notification has been enabled for this device, use this field to
determine whether or not this configuration change will be reported to the NMS.
Enter yes to report this change to the NMS.
Enter no (default) to prevent this change from being reported to the NMS.
If configuration change notification has been disabled for this modem, configuration
changes are not reported to the NMS regardless of what is entered here
A pop-up menu is available listing valid selections.
Page 2
Figure 2-12 is a sample of the input form that displays when you specify a 3400/4400 Series APL
modem with DBM.
Figure 2-12. Change Call Directory Input Form for a
3400/4400 Series APL Modem with DBM, Page 2
If the specified device is operating in Advanced mode, the input form displays all call directory
entries. If the device is operating in DATAPHONE II mode, the input form displays only the
specified directory entry.
- COMSPHERE 1
- 6800 SERIES NETWORK 1
- MANAGEMENT SYSTEM 1
- Table of Contents 3
- List of Figures 5
- List of Tables 7
- Related Documents 8
- 1Introduction 10
- NMS-Supported APL Modems 11
- Naming Conventions 12
- Device Addressing 13
- Command Access 13
- Shortcut for Command Access 14
- Wildcard Characters 14
- Multiple Entries 14
- Command Input Forms 17
- Display-only Fields 18
- Carried-over Fields 18
- Results Forms 21
- In Menus 22
- In Forms 22
- For Screen Input Fields 23
- Overview 25
- Abort (abort) 26
- Abort Command Results Form 27
- Automatic Network Test (ant) 30
- Call Detail Display (cded) 34
- Call Fault Criteria (cfc) 43
- Call Fault Read (cfr) 47
- Call Message (cm) 50
- Call Message Results Form 51
- Call Test (ct) 55
- Call Test Results Form 56
- Change Address (cha) 57
- Change Address Results Form 60
- Change Call Directory (chcd) 62
- Change Canned Message (chcm) 67
- Change Directory (chd) 69
- Change Directory Results Form 70
- Change Line Designator (chld) 78
- Change Multiplexer (chm) 79
- Change Options (cho) 81
- Change Options Input Forms 82
- Change Options Results Form 82
- Change Port Options (chpo) 86
- Change Port Speed(s) (chpsp) 88
- Change Protocol Mode (chpm) 91
- Change Thresholds (cht) 97
- (Required field) 99
- 2Modem/DSU Commands 100
- Circuit Loss Inbound (cli) 101
- (Disruptive) 101
- Circuit Loss Outbound (clo) 103
- Circuit Quality (cq) 105
- : 1–10 Hz 109
- Clear Call Directory (clcd) 111
- Page 1 for Single Devices 121
- Page 1 for Subnetwork Devices 123
- Device Test (det) 125
- Device Test Results Form 126
- Dial (dial) 127
- Dial Command Input Form 128
- Dial Command Results Form 130
- Dial Mode (dm) 131
- Dial Standby (ds) 132
- 132
- Digital Test (dit) 133
- Digital Test Results Form 135
- Disable/Enable (de) 139
- Disable/Enable Results Form 140
- Display Address (dsa) 141
- Display Call Directory (dscd) 145
- Display Canned Message (dscm) 148
- Display Options (dso) 156
- Display Port Options (dspo) 159
- Display Port Speed(s) (dspsp) 161
- Display Thresholds (dst) 165
- EIA Status (eias) 173
- End-to-End Test (eet) 179
- End-To-End Test Results Form 181
- Exception Reports (er) 182
- Exception Reports Input Form 183
- Identity (id) 188
- Page 1 for 3600 Series DSUs 191
- Page 1 for 3900 Series Modems 195
- List Directory (lsd) 197
- List Directory Results Form 198
- Loopback (lo) 199
- Loopback Test Results Form 201
- Make Busy (mkb) 202
- Manage Call Statistics (mcs) 203
- Offline Test (ot) 209
- Receive Signal Level (rsl) 210
- Receive Signal Quality (rsq) 211
- Report Terminal Power (rtp) 216
- Reset (reset) 217
- Send Message (snm) 218
- Send Tone (snt) 219
- Send Tone Results Form 220
- Service Line (sl) 221
- Signal Profile (sp) 222
- Standby Facility (sf) 226
- Standby Facility Results Form 227
- Training Time (tt) 228
- Training Time Results Form 229
- Transmit Test Pattern (ttp) 230
- Trending Reports (tr) 232
- Trending Reports Input Form 233
- Phase jitter 234
- Trending Reports Results Form 235
© 2020, manymanuals.com. All rights reserved. | 3.481 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals