Paradyne 6310 MVLT User Manual

1Hotwirer 6310 MVLt Modem Customer PremisesInstallation InstructionsDocument Number 6310-A2-GN10-40February 2000ContentsHotwire 6310 MVL Modem Overvi

98-15304a6-PinRJ11 PlugsPin #1Pin #6 10To enable the sharing of resources and review security considerations, see Microsoft’sWeb site at www.microsoft

98-16055a8-PinPlugEthernetCablePin #1Pin #8 11H The Ethernet interface connector uses an 8-pin, non-keyed modular plug.— To connect the MVL modem to a

12Optional MVL Modem Wall PlacementThe Hotwire 6310 MVL Modem is designed for tabletop placement. The MVL modemcan also be mounted on a wall. To moun

13MVL Modem Hardware TemplateFront(LEDs)98-161715.43"7.55"To BottomHole

14Hotwire 6310 MVL Modem Technical SpecificationsItem Specification*Height x Width x Depth1.43″ x 6.00″ x 8.75″ (3.64 cm x 15.24 cm x 22.23 cm)Weight

15!Important Safety Instructions1. Read and follow all warning notices and instructions marked on the product orincluded in the manual.2. Slots and o

16CE MarkingWhen the product is marked with the CE mark on the equipment label, thisdemonstrates full compliance with the following European Directiv

17Declaration of ConformityThis Declaration of Conformity is made by Paradyne Corporation pursuant to Parts 2and 15 of the Federal Communications Com

18United States – Notice to Users of the Telephone Network1. This equipment complies with Part 68 of the FCC rules. On the equipment is alabel that c

19Notice to Users of the Canadian Telephone NetworkThe Industry Canada label identifies certified equipment. This certification means thatthe equipme

2Hotwire MVL SystemCopper pairs run from the central office (CO) to the customer premises (CP) to createthe local loop. The local loop terminates on

20Warranty, Sales, Service, and Training InformationContact your local sales representative, service representative, or distributor directly forany h

3NOTES:In this document:— A telephone is used to represent any equipment that plugs into a phone jackand uses the POTS line, such as a phone, modem,

4Product-Related DocumentsTo install a phone filter, refer to the appropriate document:Document Number Document Title6035-A2-GN11 Hotwire 6035 MVL Ph

53. Connect a telephone (optional); go to Step 4 if you are not connecting a telephoneto the MVL modem.The 6035 phone filter has a cable attached. Pl

6H Use an Ethernet crossover cable and connect the other end to a PC with anEthernet Network Interface Card (NIC) installed.PHONEPOWERETHERNETLINEMVL

7The MVL modem hardware installation is now complete. When the power cord isinstalled, the MVL modem goes through a power-on self-test.Power-OnWhen p

8Status LEDsAll of the LEDs turn on and off during the power-on self-test. After a successfulself-test, the LEDs should appear as indicated in BOLD i

9LED Symptom ActionLINE LED is off.Verify that the MVL LINE cable is securely installed on bothends. If the problem continues, contact the Service Pr